Page 1 of 1
It just doesnt reach
Posted: Mon Oct 30, 2006 7:32 pm
by WoW1
When im trying to SF, my cock just wont reach... i even tryed getting the loose skin from my ballsack to reach, but couldnt do that either. Any tips on what i do?
tips, and shafts too :)
Posted: Tue Oct 31, 2006 10:38 pm
by Ziggurat
buy or build a penis pump. length of pump is not that crucial, but the width of the pump is kinda important. I have two. One that is skinny, I couldn't get into it if I was already hard, but it's long. The other is nice and wide that when I pumped i fit snuggly, and it's really long so it blows up the head nice.
Z
Posted: Tue Dec 19, 2006 8:54 am
by ryan04
My penis is only 5 1/2 inches and I get half of it in. It takes time, patience, and a lot of other things. I stretch it as far as it will go, pull it to the right with my balls above it, and pull it down past the hole-then push it in. Maybe my hole is closer. Kepp trying.
Posted: Tue Dec 19, 2006 11:03 pm
by eddy10
I have a bit of a little guy also. When I first visited this site a few months back, I thought I would try to see if I could SF. Well, I was about an inch or more short of the objective.
Now, after about 4 months of reading posts, learning, practicing and doing Jelq, the head of my cock covers the hole. I am now trying to insert. No luck yet ... but almost there. I can feel it starting to slip in a little. At the rate I am going, I figure in another month I might get a real SF going.
The moral of the story ... keep on trying, it can be done.