The toy's tactile sensation is amazing. Even in the hand with a fresh dabbing of honey dust or talc-alternative, it feels very real. Sort of loose outer skin with rigid interior for the shaft. The testes are one solid lump of rubber. The anus is pretty tight and like all UR3/Cyberskin toys requires lube for penetration. The anal passage is very close to the bottom of the toy, unlike most artifical vagina/anus toys which seem to have the passages at about the middle of the total depth of the toy. If you were to put this on a hard counter with a hard right angle at the edge, most likely you'll hurt yourself as there is less than 1/2 an inch of material between your cock and the counter top. Do not pull all the way out with this one. The toy's passage is quite long from the front of the anus to the back of the toy where the fluid exit hole is. I never poke out the end which I pretty much do with all my other fake pussy/ass toys (except Fleshlights in their tubes). The cock is a decent length, but is somewhat skinny compared to my other dildos. However, this does add to the realism in my opinion. If you want a reaming, grab a big dildo. If you want something more akin to simulation, grab this thing. In comparison, at full erection, my own cock is maybe an inch shorter than the toy, but it is also approximately a quarter to a half inch wider. I've been told I'm pretty thick by both sexes.
However, the cock is also somewhat soft. It has been attached to the toy as a separate construct and then covered over with the UR3 material. So its kinda soft, specially when compared to the the testicles. I have found that trying to insert the shaft to be somewhat difficult, and oddly enough I've taken dildos twice its girth. The shaft just feels kinda floppy about half way up. So when you're squatting over the toy, its kinda difficult to get it to go into your body during the first couple attempts. Now I've gotten over a year out of this toy, which is saying alot for these materials. But very recently I actually broke this toy while in use!! I'm very hard on this one. I was quite fond of inserting the penis right up to the balls, then rocking back and forth until the balls popped into my anus as well. Since they were a hard ball of rubber at the base of the toy, this provided an amazing 'stretched and filled' feeling. I was so stretched that it was impossible to maintain an erection while doing this, but I'd pretty much cum hands free anyway. So.. be carefull. Now that the toy is broken, I'm going to be doing some experiments with it, like hollowing out the testicles and actually placing two croaker size marbles in the sack. And of course, I'm gonna have to try and figure out how to repair the cock shaft itself, which broke off right above the balls. UR3 is a thermal-plastic material which means it can be remelted with the right conditions. I'm just gonna have to figure out what they are. The material does burn as well, so I'm not sure if I'm going to need to make a heat-based or chemical-based reaction. With name-brand cyberskin, heat just burns it. However, cyberskin melts when it comes into contact with other cysberskin toys.. so... who knows.
This toy was one of the victims. I really do need to replace it. Here's my Xhamster gallery link dedicated to the memory of a toy I was very fond of.
